About tombpcnpa

tombpcnpa · 10-29-2014

I've searched through these forums and elsewhere on the Internet but can't seem to find an answer to my problem. I have LTO 3 tapes that have Exchange 2003 backups (with granular recovery enabled). These were created with Backup Exec 10.1 These ta...

tombpcnpa · 02-03-2011

I've just upgraded from 12.5 to 2010 R2 and would like advice on tape drivers. I've followed the usual procedure of letting Backup Exec install its own drivers for my LTO 3 drives, but the driver version is the same as it was under 12.5 (5.1.37.0 dat...

tombpcnpa · 11-06-2014

Thanks to everyone who's recently replied to my question.I think I've got a handle on the situation now. The backups created with version 10.1 used brick level backup and so can't be restored to PST using version 2012. We are currently using Backu...

tombpcnpa · 11-05-2014

I've followed up some of the suggestions here and have a better idea of what's possible, but I still can't find an answer to the following question: Can Backup Exec 2012 restore Exchange 2003 data to a PST file from a backup created with Backup Exec...

tombpcnpa · 10-29-2014

Thanks for the input pkh. 1.The backup source would have been Exchange 2003 with at least SP1 as this was the base version. 2. I'm not trying to restore directly into Exchange but to use the restore to PST function of Backup Exec 2012. I'm a bit c...

tombpcnpa · 10-29-2014

Thanks for the suggestions so far. Am I correct in thinking that I should be able to run a Duplicate Backup Set job on my Backup Exec 2010 server (to a new backup-to disk folder) to get the backup job off tape. The backup-to-disk folder used is lo...

tombpcnpa · 02-03-2011

Thanks for that. I should have mentioned that my Backup Exec version number is 13.0 Rev 4164, which I presume means that the SP1 has installed correctly. What I find strange is that there is no mention in that device driver link that it is superceed...

VOX

User Statistics

User Activity

Importing legacy backup-to-disk folders with Backup Exec 2012

Backup Exec 2010 R2 LTO 3 tape drivers

Thanks to everyone who's

I've followed up some of the

Thanks for the input

Thanks for the suggestions so

Thanks for that. I should