Hello,
Netbackup 7.0.1 enviroment
Windows Master/Media (2K3)
Windows clients (2008R2)
We're testing the following restore procedure:
http://www.symantec.com/business/support/index?page=content&id=TECH87810
for our disaster recovery planning.
So far ...
Master server:
Windows Server 2003 x64
Netbackup 7.0.1
Client:
2008R2 x64 VM
Netbackup 7.0.1
Have a reoccurring issue with one of our systems. The C: and D: backup quickly (5-10 minutes), but the Shadow Copy Components are taking 14 hours or so to ...
Hello,
Since we do not currently have BMR configured in our enviroment (and adding it will require a long approval process, so we need an alternative in the meantime) we have been doing some testing on system restore following the document below:
ht...
Master + Media servers: Netbackup 7.0.1, Windows Server 2003 R2
Clients: Netbackup 7.0.1 Windows Server 2008-R2 (VMs running IIS)
Getting intermittent failures on 2 clients, both of which are IIS boxes.
Failures are typically 21, 23, 25 (c...
Hello,
At some point our barcode rules were incorrect so we wound up with a lot of tapes incorrectly labeled.
We have since corrected that issue and any tape that was still in the scratch pool has also been corrected.
However we had 18 tapes get use...
Thank you, that was what I thought.
Tested with the exact same system with more space allocated to C: to bring it up to 20GB (from the ~13GB it had), and sure enough it restored without issue.
Attached is the current log for the 2nd client which I already had in place, I've created log directories for the other client so we can check tonight.
I opened port 1556 as suggested on both clients and loaded host properties, and ran a full backup....
So I ran one of the backups with the BPCD log on, and found the following (which wasn't in the bptestbpcd results one):
<16> bpcd main: get_vnetd_forward_socket failed: 21
Searching I found the following article:
http://www.symantec.com/business/supp...
Sorry what I meant was I had tried setting the REQUIRED_INTERFACE registry entry (via the GUI option under host properties -> Universal Settings -> Use Specified Network Interface). Just mentioning it as another step I tried. There isn't a seperate b...
