Hi,
Our Scenario:
We have three backup jobs in our environment, 1. Daily Backup (Incremental) 2. Weekly Backup (Full) 3. Monthly Backup (Full).
Daily backup will write data upto 75GB within 5 hours of time on to the tapes. When comes to the Full bac...
Hi,
When I searched with techincal documentation about the hardware compression test utility in Symantec, I found SCSI Tracer Utility.
I tried to findout the .exe file in the location they mentioned i.e "c:\programfiles\symantec\backup exec folder". ...
Hi,
We have two logon accounts like bkpadmin and administrator in backup exec 2010 R2 under Netwokr Logon.
All these days I was able to run all the jobs successfully. This thursday when I tried to run Daily job, It failed and given the error code as ...
Hi,
We have some issue with the compression, we wish to contact support team of Symantec.
Before contacting them we need to know the 12 digit code. Where can we find that key?
Regards,
Ram.
Hi,
We are using Backup Exec2010 R2 for our tapes backup.
Recently we found some issue with the compression. We sent L&TT reports to the HP. They are saying that:
|__ Rule 6 - Device Configuration Rule
||__ The drive's hardware compression algo...
I know that we do not get full compression as HP guys promissed.
But at least 75% if we get that is enough for our job.
When I used Tracer Utility why it has shown the compression is disabled when all other settings are configured properly? Are there...
Hi VJware,
The above steps are already followed.
I checked with HP tools about the hardware compression and the result shown in that as 2.3:1.
Our Tape drive capacity is 154GB. When try to run the full backup our data getting crossed more than 154GB ...
Hi,
I just created a job with 2 GB of data and ran the job on an empty tape.
The compression test results shown as 1:1 when compression setting put as Hardware (if available, otherwise none). The same job run with setting like Hardware( if available,...
Hi,
I went to Tools...>Backup Exec Services. I have updated the account with recent password.
Do I need to restar the services once after changing those settings.
Without restarting I tried to edit the account details under Network logon Menu. But It...