About Jim_Bollinger

Jim_Bollinger · 09-15-2005

A job (created by a policy) was running the other night when the Job Engine service died. Now when I submit the job it goes immediately to "Recovered" status and resubmits itself 5 min in the future (retry). I tried recreating the same selections in ...

Jim_Bollinger · 08-16-2005

Article http://seer.support.veritas.com/docs/278465.htm says the following about the Remote Agent for Netware: "Backups of Netware Servers using the Remote Agent for Netware Servers (RANW) will not succeed until the RANW is updated on all Netware Ser...

Jim_Bollinger · 07-25-2005

On Netware 6.5 SP3 I am replacing an earlier Netware agent with the latest agent from BE Netware 9.1.1156.I run BESTOP, replace the files, and then attempt to BESTART. I receive the following error and the agent fails to start:NDMPD.NLM: Unable to in...

Jim_Bollinger · 06-25-2005

I'm trying to install BE v10 Hotfix 24 and receive the following error: Update could not be installed. Error code 1603. I've checked file permissions and Local Security policy. Any ideas?

Jim_Bollinger · 06-13-2005

We just upgraded our Groupwise servers to new hardware running on Netware 6.5 SP3. We are using GWTSA to backup our Groupwise post offices. Our BE v10 media servers connect to the Netware agent and perform a full backup, and this seems to be fine.How...

Jim_Bollinger · 08-10-2006

Make sure you are on 5.16 firmware or higher on the MSL Specifically 5.13 has a problem with "Drive Fetch error". If you are on 5.16 or higher, try running the calibration routine, which will reset all the limits for the robotics. What you are experi...

Jim_Bollinger · 05-10-2006

Check knowledge base article 193940

Jim_Bollinger · 11-01-2005

I put our schedule on hold and waited until after the time change, as the article suggests. When I took everything off hold after the time change, most (but not all) jobs had to be rescheduled. Wouldn't you think working through the time change would...

Jim_Bollinger · 10-28-2005

I get this problem whenever I try to catalog a v9 or v10 tape. I can get around by unchecking Tools/Options/Catalogs/Use Storage Media based catalogs.

Jim_Bollinger · 09-21-2005

Thanks for this posting. I think they're working on this now, and you saved me from doing this to my (already HF15) production servers.

VOX

User Statistics

User Activity

Job Stuck in Database

10.0 Rev 5520 Hotfix 15

Remote Netware Agent won't Restart

V10 Hotfix 24 Install Fails 1603

Netware 6.5 SP3 and GW 6.5 SP3 Incremental = Full

Re: Drive Fetch Failure

Re: Corrupt Files causing Job to report Failure

Re: Daylight savings time change caused unscheduled backup

Re: Running catalog on an upgraded 10 server produces error

Re: 5520 SP1 and Hotfix 15