VVR paused due to network disconnection

Hi.

I confirm you that after the activity on our Firewall (the rules were ok, but they didn't work properly), the situation is ok now.

The KSTATE immediately switched from ENABLE to CONNECT and the sync was ok.

Thank you very much for your best support

BR

Tiziano

  vxprint -P
    Disk group: datadg

    TY NAME         ASSOC        KSTATE   LENGTH   PLOFFS   STATE    TUTIL0  PUTIL0
    rl datarlk      datarvg      CONNECT  -        -        ACTIVE   -       -

  vxprint -P
    Disk group: datadg

    TY NAME         ASSOC        KSTATE   LENGTH   PLOFFS   STATE    TUTIL0  PUTIL0
    rl datarlk      datarvg      CONNECT  -        -        ACTIVE   -       -

- and then:

  vradmin -g datadg repstatus datarvg
    Replicated Data Set: datarvg
    Primary:
      Host name:                  172.22.8.132
      RVG name:                   datarvg
      DG name:                    datadg
      RVG state:                  enabled for I/O
      Data volumes:               1
      VSets:                      0
      SRL name:                   srl_vol
      SRL size:                   1.00 G
      Total secondaries:          1

    Secondary:
      Host name:                  10.66.11.148
      RVG name:                   datarvg
      DG name:                    datadg
      Data status:                consistent, up-to-date
      Replication status:         replicating (connected)
      Current mode:               asynchronous
      Logging to:                 SRL
      Timestamp Information:      behind by 0h 0m 0s

  vxrlink -g datadg status datarlk
    Thu Jan 29 09:29:02 2015
    VxVM VVR vxrlink INFO V-5-1-4639 Rlink datarlk has 1 outstanding write, occupying 33 Kbytes (0%) on the SRL

  vxrlink -g datadg status datarlk
    Thu Jan 29 09:29:07 2015
    VxVM VVR vxrlink INFO V-5-1-4467 Rlink datarlk is up to date