B.Exec 2012 clean install...can't run a job
We have B.Exec 2012 installed on our network.
I decided to test SDR, so I installed it on a Windows 2008 R2 stand-alone server [2012 - Version 14 Rev 1798 (64-bit) ]. My storage device is a USB external. I started a Full backup of the media server. And it wrote about 12 GB to the BEData folder. As it was still a job in process, I was looking at some config settings and the prog file hung. Regrettably, I had to hard boot the server.
Here is my question
I re-run the same job and it stays in queued status. I cancel job.
I delete the job and create a new Full and that job stays in queued status. I cancel job.
I stop/start all services and job stays in a queued status. I cancel job.
I reboot and create a tiny job to back-up and job stays in queued status.
Any ideas to get past this so I can start testing SDR?
- You should check your USB connection which is prone to being bad