Forum Discussion

Mohammad_Ahmad's avatar
Mohammad_Ahmad
Level 4
12 years ago

PD Installation Error: PureDisk 6.5.0.1 is not supported ,install PD 6.5.0.3?

One of our client is installing PureDisk 6.5 Operatin System and while installing it gives error that Puredisk 6.5.0.1 is remote office edition and not supported ,,install PureDisk 6.5.0.3 

i am really confused , tha which step i have missed

i have mounted   PureDisk Application label ISO file and ran the command

# sh /cdrom/puredisk/software/install.sh

and got the error that PD 6.5.0.1 is not supported , it is remote office edition,  

install PD 6.5.0.3 .

i am following the guide also

 

Backup and Recovery
Installing
NetBackup PureDisk
Tip-How to
Windows Server (2003-2008)
  • inn_kam's avatar
    inn_kam
    12 years ago
    after mounting the PD OS iso file
    Type the following command to run the post-installation script.
    # sh /cdrom/pdextras/pdos-postinstall.sh
     
    then dismount it 
    and again mount PD Application Server Std Client iso file 
    and reran the installation file
    # sh /cdrom/puredisk/software/install.sh
     
    Hope it helps
     
  • inn_kam's avatar
    inn_kam
    Level 6
    12 years ago
    after mounting the PD OS iso file
    Type the following command to run the post-installation script.
    # sh /cdrom/pdextras/pdos-postinstall.sh
     
    then dismount it 
    and again mount PD Application Server Std Client iso file 
    and reran the installation file
    # sh /cdrom/puredisk/software/install.sh
     
    Hope it helps
     
  • Mohammad_Ahmad's avatar
    Mohammad_Ahmad
    Level 4
    12 years ago

    oh yes i was missing this step, and now installation works

    i am also watching PD Storage pool guide and it is also mentioned there , but i have missed it

    Completing a Manual installation
    The following procedure explains how to complete a Manual installation.
    To complete Manual installation
    1 Type commands to mount the CD-ROM.
    For example:
    # mkdir /cdrom
    # mount /dev/cdrom /cdrom
    On a few hardware platforms, the CD ROM device /dev/cdrom is not
    available by default. If you cannot find /dev/cdrom, refer to the following
    section:
    “Troubleshooting the cdrom device” on page 222
    2 Type the following command to run the post-installation script.
    # sh /cdrom/pdextras/pdos-postinstall.sh
    This command might return some VxVM startup failure messages. You can
    disregard them.
    3 Unmount and eject the CD-ROM.
    For example:
    # umount /cdrom
    # eject
    4 Remove the PDOS disk from the CD-ROM drive.
    5 Proceed to the following section:
    “Verifying the installation” on page 76
    ( taken from PD6.5 Storagepool install guide page no.75)