Forum Discussion
- joeyiu7 years agoLevel 3
Hi CraigV,
Thanks, do you mean the option "Verify after backup completes" (attached)?
It's already selected, the backup speed it normal but the verify speed dropped dramatically like 6MB/min nowAny solution? Thank you.
Joe
- Gurvinder7 years agoModerator
In Job Setup -> under backup tasks there should be an option to seperately verify the data. You can try to run a manual verify the job and check the rate. If earlier one isnt performing well then this may also show same behaviour. You can cancel it if thats the case.
For recurring Verify Jobs you can setup a policy and add the backup and verify template. When you save the policy, it wil ask you to map this policy with a selection list, then you can choose the selection list where you selected the resources that you want to backup. This way after the backup completes, a seperate verify job will run post the backup Job.Ensure exclusions are set properly for backup exec processes
https://support.symantec.com/en_US/article.TECH203209.htmlYou can check the read speed of the disk. Has the disk detoriated over time ? Check system event logs and application event logs as well to rule out any disk Issues.
- joeyiu7 years agoLevel 3
thanks Gurv,
yes, the verify job on the same data is slow even after separated, I have cancelled it.
I have created a new back job and will try to run the verify job when it's finished.For policy setting, the option is grey out on my side, is it related to version?
- joeyiu7 years agoLevel 3
Dear CraigV,
Thanks, I have created a new data verify job to try, my question is, as I have to select the resources according to backup date (attached), is that mean I have to revise the selection manually everyday instead of making it a recursive one?
thank you.Joe