Forum Discussion

Neil_Blackburn's avatar
Neil_Blackburn
Level 3
19 years ago

BackupExecTapeDeviceDriverInstall Failed

I'm trying to run BackupExecTapeDeviceDriverInstall_273853.exe on a Windows 2003 Server running BE 9.1 with SP3. When the status message says 'Initialising Robotic Library Install Components' the installation stops with the following message:
'The wizard was interrupted before VERITAS Windows NT and Windows 2000 device drivers could be completely installed.'

I don't believe the robotic library components are installed, could this be the cause?

Thanks for your help.
10.x and Earlier
Backup and Recovery
Backup Exec

6 Replies

Sort By
  • Sharvari_Deshmu's avatar
    Sharvari_Deshmu
    Level 6
    19 years ago
    Hello,

    Please check the bkupinst.log for the last entry of "start time".
    In this please check for "return value: 3" or "error".

    Please paste that part of bkupinst.log

    Thanks,

    NOTE : If we do not receive your reply within two business days, this post would be marked assumed answered and would be moved to answered questions pool.
  • Neil_Blackburn's avatar
    Neil_Blackburn
    Level 3
    19 years ago
    Only five lines are recorded which are below:

    09-11-2005,16:37:17 : Executing InitInstall_MSI.
    09-11-2005,16:37:26 : Executing ConfigBEServices_MSI.
    09-11-2005,16:37:26 : vomus
    09-11-2005,16:37:26 : Executing BackupIDRDisk1_MSI.
    09-11-2005,16:37:28 : Executing CA PrepAutoLdr with target AutoLdr_PrepAutoLdr.

    Thanks,

    Neil Blackburn
  • Arnie_Spitzmach's avatar
    Arnie_Spitzmach
    19 years ago
    I had exactly the same issue, until I installed SP3. Once I installed SP3, everything was fine.
    Maybe it is an issue with your SP3 installation.

    Just thought I'd let you know my experience.

    Good Luck

    Arnie
  • Sharvari_Deshmu's avatar
    Sharvari_Deshmu
    Level 6
    19 years ago
    Hello,

    Please run a repair installation then reboot the server and then try to install the drivers again.

    Please see the technote below to run a repair installation:

    http://support.veritas.com/docs/253199

    Thanks,

    NOTE : If we do not receive your reply within two business days, this post would be marked assumed answered and would be moved to answered questions pool.
  • Neil_Blackburn's avatar
    Neil_Blackburn
    Level 3
    19 years ago
    I tried a repair installation but this did not help. As it's failing after saying initialising robotic library components I'll try removing this from the setup as we don't use it anyway.

    Thanks for your help.