Shahin
8 years agoLevel 6
Clean Tpe issue
Hi, We have en issue with our clean tape, we have a PowerVault 124T with 16 slots and BE 15. last time we get a message that the drive should be cleanup, we always use the slot 16 as temporary clea...
Shahin wrote:and put it in the slot 16 and run a enventory and run a clean job, but again after 5 minuts we get the same error, but this time the warning of cleaning the drive has disappeared and it looks like the drive has been cleaned.
FYI, running an inventory of a "regular" (ie non cleaning) slot, gives the same results as running a cleaning job. Simply put, if the cleaning cartridge gets put in the tape drive, the tape drives "does its thing" without any further assistance or intervention from Backup Exec.
The primary purpose of marking a slot as a cleaning slot is to exempt it from a whole library inventory job, so that you do not waste cleaning cycles when doing inventories. Cleaning cartridges are only good for so many cleanings, so you don't want to waste them
Hi Larry,
Thank you for your reply,
yes our library has a barcode scan and I think both clean tapes has the same barcode I will check that let you know.
we dont have enough slots to reserv one only for the cleaning tape that is why I use the slot 16 for clean and when the job is finish remove the clean option from the slot.
at the offline media I can see a cleaning tape there, should I remove it from there and put the new clean tape there and run a scan of slot and after run a clean job?
Thanks
If both of your cleaning cartridges have the same bar code, then BE is not aware that the "new" cleaning cartridge is "new". If there was a unique bar code, then a simple scan job would tell BE that there is a "new"/different cleaning cartridge available.
The workaround to re-using the same bar code (or not having bar codes at all) is to do what you asked... delete the cleaning media from the offline media section. That will delete the cleaning cartridge from the BE database. More specifically, that gets the "cleanings used" count back down to zero.
Then put the cleaning cartridge back in the library and scan it, then either run an inventory of that slot or run a cleaning job. If you are using a "CLN" style bar code, I don't even think you have to mark the slot (temporarily) as a cleaning slot, as BE should recognize the "CLN" bar code as a cleaning cartridge.
FYI, if that tape drive is no long requesting to be cleaned (because I think you mentioned that the new cartridge already got inventoried), you may not need to do any of this until the tape drive requests to be cleaned again. YMMV, some people clean "as needed", some people clean on a scheduled basis.
Hi Larry,
Thanks again for your detailed info,
Both cleaning tapes have the CLN barcode. I think do as suggested. delete the old tape from the offline media wait for the next cleaning request then put the new tape in the library scan the slot and see if the library will pickup the new tape and clean the drive.
I will keep you posted.
Thanks