My error message isn't exactly the same. This one is;
V-79-57344-33035 - Error - Mount failed.
Physical Volume Library Drive not found
My one is;
V-79-57344-33037 - Error - Mount failed.
Physical Volume Library Media not found.
So not sure if it applies. But in regards to the document reference you provided;
The job IS set to terminate if no appendable media is found, but that is what I want. I don't want it to overwrite the tape, (or another tape). The next job should wait and append to the end of the tape when the first job is finished.
I checked the drivers. I've reloaded the Symantec drivers and rebooted the server. Same result.
At the moment, what I am doing to test is;
- Put a single tape in the library that is overwritable. The storage is configured into 2 pools.
- Configure a job to run say at 2:20pm. Configure it to overwrite and use the tape that I have put into the 2nd pool. The tape itself is part of a media set and it's status is "overwriteable". The job is configured to overwrite the media.
- Configure a second job to run at 2:25pm while the other job is running. Again it's configured to grab the tape from the 2nd pool and from the same media set. It's set to Append.
- The first job will run correctly, but as soon as the second job kicks in, it fails.
If I do the exact same setup on another server, except that server just has a single slot LTO5 drive connected, it runs as it's supposed to. The 2nd job sits there with "Ready: No idle devices". When the first job finishes, the 2nd job kicks in and both complete correctly.