Yes, please review entry of ip address and hostname on DNS & hosts file ensuring it resolves properly, then run "bpclntcmd -clear_host_cache" on Appliance, then run configuration again.
Also, is there a log where this configuration is being written to in the Appliance? So i can see more of that error.
Hello,
The hostname is not resolving the ip address. Confirm the hostname by using the uname -a
Make sure the correct IP mapped with hosts name in /etc/hosts file.
Note: Linux is case sensitive upper and lower case difference also consider a different name.
Regards,
Thanks Tousif.
nslookup from both master & appliance resolved forward and reverse lookup. etc/hosts file of both master and applaince has entries of both system.
i think the part where CA certificate gets deployed means appliance master resolves appliance.
i'm just not quite sure wha'ts happening at this point of "checking host id-based deployment" that it's saying cannot resolve, cannot resolve where? what else i need to check aside from what's mentioned on the Guide.
Did you manage to solve the issue?
I got same issue when deploying netbackup virtual appliance on vmware. local DNS was setup correctly, lookup and reversed working properly, even I add hosts manually:
Appliance.network>hosts add 192.168.0.101 <FQDN> <short hostname>
and then run "appliance>configure" command, but the initial config failed also
