ContributionsMost RecentMost LikesSolutionsRe: Checksum on storage media failed to verify. Yes, I tried to repir and doesn't work :( Re: Checksum on storage media failed to verify. And one more : In Backupexec, when I click to server and restore, I choose Restore Files, then Date and Time when was backup, and then I see: This Item and all children are not included. I have a black square to select exactly what I want to recover. I select only the square wher I have Date and Time. Regards Luk Re: Checksum on storage media failed to verify. BackupExec 2012 14.0 1798 64bit. For 1000 backup have broken 5(errors: A checksum of the data has failed) Re: Checksum on storage media failed to verify. soft read 7 soft write 106 hard read 0 hard write 0 Regards Luk Checksum on storage media failed to verify. Hi. I have problem with restore data. When I wanted to this restore from tape (220GB), restore 148GB and I had error: Completed status: Failed Final error: 0xe000fe34 - A checksum of the data has failed. Final error category: Resource Errors What happened?? Re: problem with cleaning tape I check one more time hardware drivers and tests was OK. But when I check backup then I Saw that, when backup was only in drive 2 was OK. When I add backup to drive 1 was FAIL. I have problem with hardware drive, but test was OK. I must change drive. Re: problem with cleaning tape Other backups are getting OK. When I doing backup of every day - Incremental, and one of week - FULL. But when I must doing backup - "One time backup" with files or directories from storage, then I see this problem. Hardware tests are OK. Re: problem with cleaning tape I buy new cleening tape and bar code CLN001L1 and CLN002L1. I put this tape to my BE 2012. Now when I backup my project i have a problem: Tape alert - attempting to clean drive. Tape alert - Drive cleaned. The job failed with the following error: A backup storage read/write error has occurred. If the storage is tape based, this is usually caused by dirty read/write heads in the tape drive. Clean the tape drive, and then try the job again. If the problem persists, try a different tape. You may also need to check for problems with cables, termination, or other hardware issues. If the storage is disk based, check that the storage subsystem is functioning properly. Review any system logs or vendor specific logs associated with the storage to help determine the source of the problem. You may also want to check any vendor specific documentation for troubleshooting recommendations. I changed tape on the other and nothing. It's the same. Re: problem with cleaning tape I had earlier BE 11d and clean tape was in Library ML6000 with slot, but when I instaled BE 2012 sometimes I saw this problem. OK. I will add cleaning tape to BE, not in Library, but how?? Yes cleanning tape have a bar code, but normal code just like other tape not CLN and somethin number. Yes cleaning tape visible in the BE, and visible in Library ML6000. Re: problem with cleaning tape When I clean job retry, I have this: e000810d - Physical Volume Library Media not found. requested media not found