Forum Discussion

4 Replies

Sort By
  • SymTerry's avatar
    SymTerry
    Level 6
    10 years ago

    from the CLISH, Manage > FibreChannel > Show should give you what you want to see

  • NavGee's avatar
    NavGee
    Level 5
    10 years ago

    I'm pretty sure that would only show the wwn's of the hba's not the wwn's for the LUN's presented to the appliance.

     

     

    Regards

  • chashock's avatar
    chashock
    Level 6
    10 years ago

    That depends on when you run it.  The LUNs aren't permanently mounted to the appliance, only the snapshot LUN is during the backup.  So if you run it while there are no backups running, you are partially correct.  It will show you the WWNs of the ports you're connected to as well as the WWNs of the HBAs.  If you run it during a backup, you should see the LUNs.

  • NavGee's avatar
    NavGee
    Level 5
    10 years ago

    The above explanation sounds like VCB, I thought with NBU 7.6 the processes are as follows:

    (direct write from the datastore to the storage unit are you saying that the during the snapshot phase the datastore is mapped to the backup host please clarify? )

     

    Phase 1

    The NetBackup master server initiates the backup.

    Phase 2

    The NetBackup client on the VMware backup host initiates a VMware
    snapshot on the virtual machine.

    Phase 3


    Windows: VSS synchronizes the file system on the virtual machine.
    Linux: The SYMCquiesce utility can quiesce the file system on supported
    Linux operating systems.

    Phase 4

    The VMware server creates a snapshot on the virtual disk datastore.

    Phase 5

    The NetBackup client reads the snapshot from the datastores and writes
    the data to the NetBackup storage unit.