ContributionsMost RecentMost LikesSolutionsServer hangs after running any job using Backup Exec 10Hi there, I am using Backup Exec 10, and whenever i run a job, be it a normal data backup form another server, or my exchaneg server, or even my Oracle databases, the Job fails and the server hangs after that . Below are some of the error meesages I have received. < Falcon Exchange IS Backup -- The job failed with the following error: A failure occurred querying the Writer status. Category: Job Failed Type: Error Server: PHOENIX Device: Servers Backup-to-Disk Folder Job name: Falcon Exchange IS Backup Time alert received: 6/9/2005 1:00:10 AM Source: Job Properties of Category: Job FailedEnabled: Yes Send notifications: No Record in event log: Yes Event ID: 34113 Automatically clear: No Include job log: No > < G: Drive Backup Daily -- The job failed with the following error: An error occurred during the snapshot cleanup, or could not locate a snapped volume from which to back up. Category: Job Failed Type: Error Server: PHOENIX Device: Servers Backup-to-Disk Folder Job name: G: Drive Backup Daily Time alert received: 6/6/2005 8:39:47 PM Source: Job Properties of Category: Job FailedEnabled: Yes Send notifications: No Record in event log: Yes Event ID: 34113 Automatically clear: No Include job log: No > Awaiting your reply on this issue. Regards, Merrill.Message was edited by: Merrill Correia This is the log entry for the job. < G: Drive Backup Daily -- The job failed with the following error: An error occurred during the snapshot cleanup, or could not locate a snapped volume from which to back up. Category: Job Failed Type: Error Server: PHOENIX Device: Servers Backup-to-Disk Folder Job name: G: Drive Backup Daily Time alert received: 6/6/2005 8:39:47 PM Source: Job Properties of Category: Job FailedEnabled: Yes Send notifications: No Record in event log: Yes Event ID: 34113 Automatically clear: No Include job log: No >NAS Server running backup exec hangs almost every dayThe NAS server runnign backup exec 9.1 on it, hangs almost everyday. The SYSTEM error that i get is as below, Event ID: 10010 Descrip: The server did not register with DCOM within the required timeout. The APPLICATION error i get is as follows: Source: MSSQL$BKUPEXEC Event ID:17052 Description: Eror 17803, Severirty:20, State: 17 Insufficient memory. Please advice on what could be wrong. Does this have anything to do with IDR??? Server Specs: HP Storageworks NAS 1200s P4 2.4 GHz, 512 MB RAM.