Backup Exec 12.5

Hi,

You'd need to replace the drive if it's broken and then that would sort it out.

What is the make of the device? If HP, get hold of HP Library & Tape Tools and run the diagnostics to rule out hardware errors.

You can also go into your Media tab in BE, and check those tapes for excessive errors. If possible, also try with a new tape and see if the error persists...

Thanks!

Thank you for your answer.

All tapes were changed with new tapes but the error persists.

It's a Terra device. I will check if I can run a diag on the device.

Thanks

 Have you tried to run the same job on a B2D folder to isolate the tape issue?

You can also use NTBackup to verify the tape drive fumctionality.(If diagnostic tools from vendor are not available with you)

Regards..

(Server: "backup") (Job: "Weekly Full Backup") Weekly Full Backup -- The job failed with the following error: A tape read/write error has occurred.  This is usually caused by dirty read/write heads in the tape drive.  Clean the tape drive, and then try the job again.  If the problem persists, try a different tape.  You may also need to check for problems with cables, termination, or other hardware issues.

this can be a issue with the tape drive. what does the diagnostic logs say?

thanks

What do you need in the diagnostic file, they are so many information...

In event viewer I have :

event id 33152

adamm mover error : read failure!

Error = ERROR_CRC

Drive = "HP1'

Media = "LTO0008"

Do you want that I add the log file?

Kind regards.

Hi David,

Have you selected write test while doing the diagnostic tests? If selectes what was the result of that test?

Regards..

...at first read, that looks like an error with the tape, but you need to run a diagnostic check on your hardware to rule that out.

 Try a test backup on a B2D folder to isolate the TAPE issue...