Forum Discussion

fuadsm's avatar
fuadsm
Level 3
17 years ago

Hanging when enabling mailboxes for archiving

Dear All,
Does any one have an idea about the following problem:
I have two exchange servers for archiving: ex1 and ex2. However, I am logged in with the service account for EV to the EV server and I can enable mailboxes from ex2 but I cannot do that with ex1.
 
The vault service account is a local administrator on both servers and has full security permissions on both servers including 'send as' and 'receive as' and has its mailbox on ex1. I tried with the second account that has mailbox on ex2 and assigned local administration on ex1 and ex2 and 'send/recieve as' as well as "Power Administrator" and "Exchange administrator" roles in EV and still the same problem.
 
When I try to enable mailboxes manually using the EV service account, the console hangs. It does not give errors in the event viewer.
Note that the provisioning task is working OK and I don't face anyproblem with it.
 
If you have any idea please reply,
 
Best Regards,
Fuad
Enterprise Vault
Information Governance

4 Replies

Sort By
  • MichelZ's avatar
    MichelZ
    Level 6
    17 years ago
    And there is no error whatsoever?

    Could you try to do this via EVPM Script?
    Maybe you get some better error message there...

    Regards
    Michel
  • Carroll_EMC's avatar
    Carroll_EMC
    17 years ago
    We're having a simular problem. We've installed and configured Symantec Enterprise Vault and there are no errors in the event log. When trying to enable mailboxes for archiving, we can select from the list of mailboxes, but when trying to enable them the console freezes. We've let it sit for 10 minutes and it stays the same until the console task is ended. Does anybody have a solution to this?
     
    Thank you,
    IT Support
    Carroll EMC
  • Mushroom's avatar
    Mushroom
    17 years ago
    I have the same setup  - 2 Exch & 1 EVLT . Exch2 could Archive manually fine but Exch1 would hang. I let it sit for a couple of hours and I found no errors in the logs.
    I set the Automatically enable Mailboxes in the Provisioning Group Properties and reran the task on the Exch1. After an hour all the mailboxes had been archived. I removed the check mark and I can now manually add mailboxes.