Forum Discussion

dwilson's avatar
dwilson
Level 4
12 years ago

Copying Files From Appliance

Can someone explain to me how to copy files from an appliance to a Windows client? I hve tried utilities such as Winscp and PSCP without any luck.

Backup and Recovery
Basics
Configuring
Linux
Managing Backup Devices
NetBackup Appliance
Tip-How to
Training
  • Mark_Solutions's avatar
    Mark_Solutions
    12 years ago

    What files do you need?

    If they are logs of any sort then just go to Support - Logs - Share Open and map a drive to \\appliancename\logs\ using appliancename\admin and your password

    This displays the O/S, Appliance and NetBackup logs all within that folder.

    It is also handy as you can go into the O/S (Support - Maintenance) and cp a file to say /usr/openv/netbackup/logs/ and then see it in the logs share to copy it off

    Hope this helps

9 Replies

Sort By
  • dwilson's avatar
    dwilson
    Level 4
    12 years ago

    DOH!!! Was doing to many things at once. I have corrected the Solution. Thanks again.

  • Mark_Solutions's avatar
    Mark_Solutions
    Level 6
    12 years ago

    OK great - would have been nice if you had marked the comment that led to the solution to assist others searching for a similar thing in the future - Thanks

  • dwilson's avatar
    dwilson
    Level 4
    12 years ago

    Mark - this is exactly what I needed in order to FTP over my log files....Thanks.

  • Mark_Solutions's avatar
    Mark_Solutions
    Level 6
    12 years ago

    What files do you need?

    If they are logs of any sort then just go to Support - Logs - Share Open and map a drive to \\appliancename\logs\ using appliancename\admin and your password

    This displays the O/S, Appliance and NetBackup logs all within that folder.

    It is also handy as you can go into the O/S (Support - Maintenance) and cp a file to say /usr/openv/netbackup/logs/ and then see it in the logs share to copy it off

    Hope this helps

  • dwilson's avatar
    dwilson
    Level 4
    12 years ago

    Sorry ours is a 5220 and on 2.5.1 as well. Ed I will give you commands a try an report back. Also do you have any documentation or could you explain what the commands do? I am fairly new to the Appliance/Linux environment, so trying to learn everything I can.

  • Ed_Carter's avatar
    Ed_Carter
    Level 4
    12 years ago

    On our 5220's think Winscp worked fine on 2.5 but after installing 2.5.1 wouldn't work anymore.

    Try this from maintainance (elevate)

    mv /admin/.bashrc /admin/.bashrc.back

    You should now be able to connect WINSCP to the appliance using the admin account. When finished remember to run the reverse.

    mv /admin/.bashrc.back /admin/.bashrc

    Cheers

     

    Ed

    • tkahfock1's avatar
      tkahfock1
      Level 1
      4 years ago

      Hi,

      i got message as below

      '/admin/.bashrc.back' : Permission denied