Forum Discussion

Jason_Starkey's avatar
Jason_Starkey
Level 3
18 years ago

Not Sticking To Schedule

I have a number of jobs setup to run on schedules. Ocassionally I have to go in and run them now...which pops up a message box stating that if I run this now, it will still run on schedule.

Once the job finishes, I notice it no longer shows up in my Job Monitor tab to run when it is suppose to run.

I look at the job itself, and noticed it is no longer set on a schedule....This should have stayed on schedule...anyone else having this same issue?
11.x and Earlier
Backup and Recovery
Backup Exec

4 Replies

Sort By
  • Bradley_Willads's avatar
    Bradley_Willads
    Level 5
    18 years ago
    Jason,

    This is the first I have heard of this issue. Is the reproducable all the time?

    Have you install Hotfix 10 yet? This resolved some scheduler issues. You can download it here:

    32bit:
    http://support.veritas.com/docs/287164

    x64bit:
    http://support.veritas.com/docs/287163
  • Jason_Starkey's avatar
    Jason_Starkey
    Level 3
    18 years ago
    Bradley,

    Thanks for the isight to the latest hotfix...loading it now. I'll post back the outcome.

    Is this for me has been reproducable. Everytime I go to a job that was set on schedule and perform a Run Now task, it completely cuts out the schedule, and change the job entirely to Run Now.

    Thanks again!
  • Yep's avatar
    Yep
    Level 2
    18 years ago
    Well after much digging, even in this forum, going through the useless email support, the complete lack of phone support because I am demoing the software I found this. I hope this can help others.Symantec sure does not give a hoot.
    http://support.veritas.com/docs/288393