BackupExec + S3 [A backup storage read/write error has occurred]
Hi,
We have BackupExec 20.4 with StoreOnce on premise and use Amazon S3 with Storage Gateway for Virtual Tape Library (VTL).
My jobs create backup onsite on StoreOnce and then they are pushed to the cloud via AWS S3 with a duplicate job.
I only get this error from time to time and have already checked with my ISP, VPN Network team and opened a ticket with AWS.
I ask if anyone can help me out with these failures that occur:
Job ended: venerdì 19 giugno 2020 at 02:27:11
Completed status: Failed
Final error: 0xe00084c7 - A backup storage read/write error has occurred. If the storage is tape based, this is usually caused by dirty read/write heads in the tape drive. Clean the tape drive, and then try the job again. If the problem persists, try a different tape. You may also need to check for problems with cables, termination, or other hardware issues. If the storage is disk based, check that the storage subsystem is functioning properly. Review any system logs or vendor specific logs associated with the storage to help determine the source of the problem. You may also want to check any vendor specific documentation for troubleshooting recommendations. If the storage is cloud based, check for network connection problems. Run the CloudConnect Optimizer to obtain a value for write connections that is suitable for your environment and use this value to run the failed backup job. Review cloud provider specific documentation to help determine the source of the problem. If the problem still persists, contact the cloud provider for further assistance.Final error category: Backup Media Errors
Duplicate- VMVCB::\\XXXXX\VCGuestVm\(DC)XXXX(DC)\vm\XXXX
An unknown error occurred on device "HPE StoreOnce:3".V-79-57344-33991 - A backup storage read/write error has occurred. If the storage is tape based, this is usually caused by dirty read/write heads in the tape drive. Clean the tape drive, and then try the job again. If the problem persists, try a different tape. You may also need to check for problems with cables, termination, or other hardware issues. If the storage is disk based, check that the storage subsystem is functioning properly. Review any system logs or vendor specific logs associated with the storage to help determine the source of the problem. You may also want to check any vendor specific documentation for troubleshooting recommendations. If the storage is cloud based, check for network connection problems. Run the CloudConnect Optimizer to obtain a value for write connections that is suitable for your environment and use this value to run the failed backup job. Review cloud provider specific documentation to help determine the source of the problem. If the problem still persists, contact the cloud provider for further assistance. V-79-57344-65072 - The connection to target system has been lost. Backup set canceled.
I can't try cloudconnect optimizer because it's a iScSi connection.
Any help would be great.
Thank you,
Federico Pieraccini
this mostly seems to be a case with network drop. If bengine, device and media (and from settings -> device and media ->enable verbose) is selected in SGMON.exe ( BE Install Path) and backup is run and if the job fails with this error. Review the 2060* and other errors seen during the time in SGMON Log ( BE Install Path\Logs ). To check the time when the error is seen, expand the failed job log and check the exact time when the error is encountered in the job
