Forum Discussion

ycesur's avatar
ycesur
Level 3
16 years ago

Error Code E00084EC

Hi all,

I have Backup Exec12.5 running on Windows Storage Server 2003 x64 R2 SP2 Standard Edition. I have installed the Backup Exec Service Pack 2 and Hotfix 324011about 10 days ago. Since then I started receiving the following errrors with above error code in the notification emails.:

____________ 
Backup- E: 
Storage device "IBM 1" reported an error on a request to write data to media.

Error reported:

A tape read/write error has occurred.  This is usually caused by dirty read/write heads in the tape drive.  Clean the tape drive, and then try the job again.  If the problem persists, try a different tape.  You may also need to check for problems with cables, termination, or other hardware issues.

V-79-57344-34028 - A tape read/write error has occurred.  This is usually caused by dirty read/write heads in the tape drive.  Clean the tape drive, and then try the job again.  If the problem persists, try a different tape.  You may also need to check for problems with cables, termination, or other hardware issues.

A selection on device \\MELFILE\Utility Partition was skipped because of previous errors with the job.

A selection on device Shadow?Copy?Components was skipped because of previous errors with the job.


 
Backup- MELFILE
Storage device "IBM 1" reported an error on a request to read data from media.

Error reported:

Incorrect function.

V-79-57344-34030 - An invalid command was sent to the storage device.


 
Verify
Storage device "IBM 1" reported an error on a request to read data from media.

Error reported:

Incorrect function.

V-79-57344-34030 - An invalid command was sent to the storage device.

_________


I cleaned the tape head every day for the last 8 backup days and I used a brand new tape last weekend with no luck.


I did not touch the server before and after the Backup Exec update so it cannot be a hardware (cable, terminator etc. problem)  and there is no nerwer updates available for this platform.

Can anyobody give me any ideas on how to fix this problem please? 

Should I uninstall Service Pack 2 and Hotfix?


Kind Regards,


Yilmaz Cesur.
12.x and Earlier
Backup and Recovery
Backup Exec
Windows
  • ycesur's avatar
    ycesur
    15 years ago
    Hi everyone,

    I forgot to say that I had resolved this issue after Dell sent me updated drivers.

    Thanks all anyway.
  • CraigV's avatar
    CraigV
    Moderator
    16 years ago
    I'd start with the Hotfix. Uninstall it, and see if you can get a backup through.
  • ycesur's avatar
    ycesur
    Level 3
    16 years ago
    Hi Craig,

    Thanks for the comment. I tried it but unfortunately there is no option to uninstall the Hotfix or the service pack neither within Backup exec nor in "Ad Remove Programs" in Control Panel.

    Dell was the supplier of all hardware and software and they have provided driver and firmware updates which I will install this weekend to see if they will fix the problem.

    The backup is actually working but it gives me a faulty report saying that the head is dirty and it does eject the tape so I have to clean the tape head every day.

    Thanks again,

    Regards,

    Yilmaz..


  • ycesur's avatar
    ycesur
    Level 3
    15 years ago
    Hi everyone,

    I forgot to say that I had resolved this issue after Dell sent me updated drivers.

    Thanks all anyway.