HI,
SMASH is so easy, just type help ...
To start consoole on 5240, you should first activate SOL redirection in the configuration interface of the IPMI dedicate port (otherwise it will not work, but you can do it with the SET command in SMASH CLP under the right ufip=/ )
After, ssh IPMI board and get the SMASH CLP working
To start the SOL console, just type :
->start system1/sol1
COMMAND COMPLETED :
start system1/sol1
ufip=/system1/sol1
Enter ~. to exit from SOL
setting the MUX for SOL
********************************************
* Welcome to NetBackup Appliance 3.0 *
********************************************
Installation status: Completed (Wed Mar 22 05:03:07 PDT 2017)
spa-abck001.coyote.local login:
********************************************
* Welcome to NetBackup Appliance 3.0 *
********************************************
Installation status: Completed (Wed Mar 22 05:03:07 PDT 2017)
spa-abck001.coyote.local login:
To exit redirection, it's like when your connected on a traditionnal serial port (/dev/ttyS0)
standard SOL command like " ~. " or " ~? " , etc.. are working
Hope it could help
PS : SMASH CLP is a standard from DTMF, working on Intel / Xilink / Aspeed / etc... baseboard management controler used in every MegaraC/DRAC/BMC/ILOM/etc. management interface
The Command Line Protocol is just a set of : show / set / start / stop, etc... command describing services and config in a standard directory tree. Be carefull, it's richer than a simple directory tree !
Regards