BMR Restore issues
- 9 years ago
Well here is why it went into DDR.
"
DEBUG ddr_detect.cpp:IsDissimilarDiskRestore() The saved and discovered disks do not match, running DDR,"
Did you initialize the edited config with the discovered config?
Now to the meat of it:
2 DEBUG CWindowsVdsFacade.cpp:importDisk() Could not find disk pack for disk \Device\Harddisk0 1 DEBUG CWindowsVdsFacade.cpp:getPack() Failed to get disk pack for disk ID: 26b92f66-62d2-4d6e-b1a8-b10e907142bb 2 DEBUG CWindowsVdsFacade.cpp:importDisk() Failed to add disk \Device\Harddisk0 into basic disk pack. 2 DEBUG CWindowsVdsFacade.cpp:clearDisk() Could not import disk. 3 DEBUG CWinPeLdmDiskRestoreWorker.cpp:clearDisk() Could not clear the disk, rc=10004 Root Cause: <?> 3 DEBUG CWindowsLdmDiskRestoreWorker.cpp:initializeDisk() Could not clear the discovered disk, name=\Device\Harddisk0, rc=1 3 DEBUG CWindowsLdmDiskRestoreWorker.cpp:createDiskGroups() Could not initialize disk, name=\Device\Harddisk0, rc=1 3 DEBUG CWindowsRestoreStrategy.cpp:configureDisks() Disk configuration step failed. 4 DEBUG CWindowsRestoreStrategy.cpp:retry() Retrying disk step: Create Disk Groups 4 DEBUG CWinPeDiskRestoreStrategy.cpp:updateStep() Retrying... 4 DEBUG CWinPeDiskRestoreStrategy.cpp:step() Current step=Create Disk Groups 1 DEBUG CWindowsVdsFacade.cpp:IsDynamic() GetPack failed, ret=-2147212265
There was an issue in 7.6 that should have been resolved in 7.6.0.2, but for sure was added to 7.6.1 bmrrst code that involved checking disks on a newly created vm to find out if they were dynamic or not which was hindered by the new disk being un-intialized.
The following did result in a workaround. (Let me know if you need infomration on how to bring up a command prompt on the booted restore environment.
Workaround:
At time of failure, bring up a command prompt on the client and perform the following commands:
diskpart
select disk 0
clean all
create part primary
active
format fs=ntfs quick
assign letter=c:Then restart the restore.