Forum Discussion

Rami_Nasser1's avatar
Rami_Nasser1
Level 6
10 years ago

QNAP NAS as Storage device for netbackup 7.6

Hi All

Hope you are doing fine.

I configured my master server (netbackup 7.6) on windows 2008 r2 server (virtual environment),and I would like to add my nas storage as a storage device for  backup my data .I lloked for any document describing such configuration but failed.Do any body used such configuration?

FYI My QNAP NAS not provisioned yet and I can create storage pool that contain volume or Lun.

Regards,

7.6
Backup and Recovery
NetBackup
Windows Server (2003-2008)
  • Marianne's avatar
    Marianne
    10 years ago

    Have you had a look at Service requirements in the post that I have linked above?

    Add the path in Basic Disk Storage Unit as UNC path.

    Next, change logon service for these 2 NBU services to a Domain user with full rights to the share:

    • NetBackup Client Service

    • NetBackup Remote Manager and Monitor Service

    See http://www.symantec.com/docs/HOWTO34525  

8 Replies

Sort By
  • Marianne's avatar
    Marianne
    Level 6
    10 years ago

    What type of backup storage? Basic or Advanced disk?

    Any locally mounted file system or NFS/CIFS is supported with Basic or Advanced disk.

    The Hardware Compatibility Guide says this about Advanced Disk:

    The storage must be seen as local disk by the NetBackup Media Server.

    Connection method of the disk array (parallel SCSI, Fibre Channel, iSCSI, etc) is not a determining factor for support, only that the storage is seen as local disk by the NetBackup
    Media Server.
    AdvancedDisk functionality is subject to all functional limitations as imposed either by the operating system or by the underlying file system.

    Information about Basic Disk in Admin Guide I. 
    You will notice that no particular disk manufacturer is explicitly qualified.

  • Rami_Nasser1's avatar
    Rami_Nasser1
    Level 6
    10 years ago

    Thank you Marianne.

    I prefer to use basic Disk.

    A BasicDisk type storage unit consists of a directory on a locally-attached disk or a network-attached disk that is exposed as a file system to a NetBackup media server. NetBackup stores backup data in the specified directory.

    My understanding :I will create avolume in my NAS and create a shared folder with read write permission.

    Then from the master server (windows machine) map network drive?

    or no need for this step and go forward to create basic storage and add the network- attached disk

    Regards

  • Marianne's avatar
    Marianne
    Level 6
    10 years ago

    Have you had a look at Service requirements in the post that I have linked above?

    Add the path in Basic Disk Storage Unit as UNC path.

    Next, change logon service for these 2 NBU services to a Domain user with full rights to the share:

    • NetBackup Client Service

    • NetBackup Remote Manager and Monitor Service

    See http://www.symantec.com/docs/HOWTO34525  

  • Rami_Nasser1's avatar
    Rami_Nasser1
    Level 6
    10 years ago

    Thank you Marianne.

    It was very important to modify the mentioned services using domain admin with full previliges for shared unc path.Through configuration  I discovered that my account is not domain admin and i was unable to modify the services.now my account able to modify the services and the backup working fine.