Charlie126
16 years agoLevel 2
HP ML110
Hi, Has anyone managed to successfully restore an BESR image onto a HP ML110 G5 Proliant server with RAID enabled from the BIOS? Kind Regards Message Edited by Charlie126 on 12-23-...
I have tried for the last couple of days to restore to an HP ML110. I however didn't have the problem you did. After the first boot the system did decide to sort out the HAL and then reboot to then start the process again. I left this to happen for 12 hours before resigning and accepting the fact that the software could even handle a small change.
In case you are wondering I backed up the system, which at this point ran on a single 74GB SATA HDD. The rebuild was to the same hardware bit this time I had 2 500GB SATA HDD's in a raid 1 config.