Cannot obtain settings for the Agent For Windows publishing from the registry
Hello. Our Backup Exec version 16 is running on a Windows Server 2016. We are unable to upgrade it because we run a software on one server that can only be supported on Windows Server 2003. The Windows 2003 server was suddenly not backing up properly. Restart did not work and I reinstalled the agent. Now when I try to install it, it does not show up in my backup exec because you need to enable publishing in the Agent on the 2003 server. However, when I try to do that by going to the publishing tab, I get an error message "Cannot obtain settings for the Agent For Windows publishing from the registry". It then goes to the tab but the checkmark is greyed out. I also noticed the Backup Exec Agent for Windows service is stopped. It automatically closes if you try to start it saying it closes it if the service is not in use. I have tried both installing the agent manually and pushing from the backup exec server. It installs fine but you cannot enable the publishing. I also tried deleting every backup exec file, folder, and registry key I could find to fully reset it before reinstalling. Other servers work fine. How can i fix this? Please let me know. Thank you.
NDMP backups failing
I have an ancient tape backup sysytem that I use as a redudndant data backup for my Netapp FAS2020 filer. It has worked flawlessly for 7 or 8 years, until a controller on the Netapp crashed last week. It was replaced and is running normally, and supposedly the same config was applied as prior to the crash. But ever since then my backups have been failing with Error Code E00846B: (Server: "DOCULEX") (Job: "NDMP-Policy 0001-Daily Backup") NDMP-Policy 0001-Daily Backup -- The job failed with the following error: The resource could not be backed up because an error occurred while connecting to the Backup Exec for Windows Servers Remote Agent. Make sure that the correct version of the Remote Agent is installed and running on the target computer. If the server or resource no longer exists, remove it from the selection list. Edit the selection list properties, click the View Selection Details tab, and then remove the resource. I have deleted and recreated the items in the selection list, tried two different logons to the device, rebvooted teh media server, ascertained that the media server can ping the Netapp. I am at a loss. Any help would be greatly appreciated.
Error code 48
Dear All, I add new unix client on the NBU console, and test the backup, but the client hostname could not be found (48), then I already add the host name on the media server, master server, run the bptestbpcd -client hostname -verbose -debug, with the exit code = 0 then run the backup for testing, but still to get the error code 48. Kindly to advice the issue I get this error code even hostname existing in the master and media server. Thanks,Restore failed after copying media folder back to original location
I copied some of the old media folders to free up disk space for backup. Now I need to restore from one of the old media folders, I copied it back to the original location, I ran catalog and inventory of the media successfully, but the restore failed. Error category : Resource Errors Error : e000848c - Unable to attach to a resource. Make sure that all selected resources exist and are online, and then try again. If the server or resource no longer exists, remove it from the selection list. Edit the selection list properties, click the View Selection D Please advise me what I should do to fix this
