SFHA Solutions 6.0.1: Reattaching failed disks using the Veritas Volume Manager (VxVM) vxreattach command

[Vivian_Wu]

You can perform a reattach operation if a disk could not be found at system startup, or if VxVM is started with some disk drivers unloaded and unloadable (causing disks to enter the failed state). If the underlying problem has been fixed (such as a cable or controller fault), use the vxreattach command to reattach the disks without plexes being flagged as STALE.  The reattach must occur before any volumes on the disk are started.

For more information on the reattach operation, see:

• Restoring communication between host and disks after cable disconnection (Linux only)
• Reattaching failed disks
• Recovering from disruption of connectivity to storage at the remote sites from hosts on all sites

vxreattach (1M) 6.0.1 manual pages:
AIX
HP-UX
Linux
Solaris

Veritas Storage Foundation and High Availability documentation for other platforms and releases can be found on the SORT Website.