03-17-2011 06:10 AM
Installed Agent manually on Netware 6.5 SP8 server per: (README states remote push no longer supported).
Backup EXEC 2010 R2 - Fresh install
http://www.symantec.com/business/support/index?page=content&id=HOWTO24144
When Running BESTART manually I see - "error 1006 unable to load required module ndmpd.nlm" in the Surestart console
When BESTART is run at reboot by autoexec.ncf I see - "Error 1004 timeout waiting for NDMPD.nlm to initialize." in surestart Console
NOTE: -!X is present in the BESTART file
Per Novell TID:
http://www.novell.com/support/viewContent.do?externalId=7002947&sliceId=1
Edited startup.ncf :
removed LOAD NWTAPE.CDM a
added SET Auto Load of CDM Modules = OFF
no commands with NWTAPE.CDM present in autoexec.ncf
Also verified that NWPA.NLM was loaded (this was referenced in an older post I found but seems to be regarding older versions of BE).
Any help is appreciated, Thanks.
Solved! Go to Solution.
03-18-2011 03:43 PM
After working with escalated support, loaded the NDMPD.NLM manually from the console and then ran BESTART.
After that we could see the Netware servers on the media server.
As a perma fix added:
LOAD SYS:/bkupexec/nlms/ndmpd.nlm
to autoexec.ncf before bestart is loaded.
Props to:
Jim Rustick
Advanced Technical Services Engineer
For the help on this.
03-18-2011 03:43 PM
After working with escalated support, loaded the NDMPD.NLM manually from the console and then ran BESTART.
After that we could see the Netware servers on the media server.
As a perma fix added:
LOAD SYS:/bkupexec/nlms/ndmpd.nlm
to autoexec.ncf before bestart is loaded.
Props to:
Jim Rustick
Advanced Technical Services Engineer
For the help on this.