11-15-2012 11:22 AM
Hi,
I am trying to see whether the job status codes have changed in Backup Exec 2010+. I noticed:
JOB STATUS: 1 (Running)
from "bemcmd -o16 -i <job_id>" command. In previous versions job status 1 was considered cancelled. Where can I find all latest job status codes? I would like to see job status codes for Backup Exec 2012 as well.
Thank you.
Ramassh
Solved! Go to Solution.
11-21-2012 05:46 AM
Pg. 30 of that guide states that 1 shows as successful! -1 is failed.
11-15-2012 12:36 PM
Hi Ramassh,
If you haven't seen the link below, please check it out:
https://www-secure.symantec.com/connect/forums/looking-list-backup-exec-job-stauts-codes
Thanks!
11-15-2012 01:12 PM
Hi Craig,
Yes, I saw that. Since it was a July 2009 posting, I think it is not valid for Backup Exec 2010+. I can already see the job status mismatch for:
JOB_STATE_CANCELED = 1 The job has been terminated because it was canceled.
Which is incorrect as I can see in the command output.
Thanks
Ramassh
11-15-2012 10:15 PM
This is the link for the BEMCMD command line applet for BE 2010.
http://www.symantec.com/business/support/index?page=content&id=TECH126925
This would therefore be relevant for your version.
Thanks!
11-19-2012 07:29 PM
Hi Craig,
Thanks for that doc. It still says:
JOB_STATE_CANCELED = 1 The job has been terminated because it was canceled.
But in the BEMCMD output I see:
JOB STATUS: 1 (Running)
It is correct - running. So is job status 1 really cancelled? Or am I not reading the command output correctly?
Please help. Thanks.
11-21-2012 05:46 AM
Pg. 30 of that guide states that 1 shows as successful! -1 is failed.