Hi, I have a problem after install the Ralus in a red hat 5.8
I check the services and the 10000 is free for use. I also tried to change the port, but the error is the same.
I disable the IPV6 at /etc/modprobe.conf, reboot the server, but nothing, same errors.
Any idea ?
41a97940 Tue Jun 26 09:10:02 2012 : INFORMATIONAL: Zero value found for 'DisableRMAL' from ralus.cfg, allowing RMAL to initialize
41a97940 Tue Jun 26 09:10:02 2012 : Successfully resolved the "ndmp" service to port: 10000 (host order)
41a97940 Tue Jun 26 09:10:02 2012 : BETCPListener successfully installed a signal handler for SIGTERM
41a97940 Tue Jun 26 09:10:02 2012 : BETCPListener::BETCPListener: This system appears to be a Dual IP system
41a97940 Tue Jun 26 09:10:02 2012 : BETCPListener::BETCPListener: Successfully set the IPV6_V6ONLY option, this listener may behave as Dual Stack listener
41a97940 Tue Jun 26 09:10:02 2012 : BETCPListener::Bind: Could not bind to port 10000 on IPv6, An error occurred during a socket bind operation: Error Code: 98, System Error Message: Address already in use
41a97940 Tue Jun 26 09:10:02 2012 : BETCPListener::Bind: Could not bind to port 10000 on IPv4, An error occurred during a socket bind operation: Error Code: 98, System Error Message: Address already in use
41a97940 Tue Jun 26 09:10:02 2012 : Could not start NDMP Listener on port 10000: An error occurred during a socket creation operation: Error Code: 98, System Error Message: Address already in use
41a97940 Tue Jun 26 09:10:02 2012 : ndmpRun: exiting
