Hi,
When we run a cleaning job on our library, the job starts, goes to about 10% and then just sits there until we cancel the job a couple of hours later.
There is not tape picked, even though there is a new cleaning tape in a slot designated as cleaning slot. Backup Exec acknowledges that it's a cleaning tape by naming it a cleaning tape, putting it in the cleaning media set and by showing it online.
There is nothing logged in the Windows events, nor in the Library FSC logs.
Since we have two drive in the library, I already tried to disable the one we're not trying to clean. Without success.
basically the jobs runs, but doesn't do anything.
We use a Storagetek L20 with two drives, an LTO1 and an LTO3.
Anyone who's had the same problem?
regards,
Bart