About paul_klump

paul_klump · 02-09-2010

I'm currently in the midst of installing a backup solution on my work network. I have a server running Windows 2003 Server and have installed BackupExec 12.3. On this same network, I have a Netgear ReadyNAS 1100. I am able to connect to the ReadyN...

paul_klump · 03-11-2010

James, I haven't replied back in a while, but I would like to report that I've successfully been able to back up my Windows servers via BE, and was able to perform a system restore of a test server using an IDR boot CD. I'm not sure if the errors I...

paul_klump · 02-18-2010

James, I had been out of the office most of the week, but I had let that backup job just sit there and run. It looked like it just went into a paused state. I then went to the drive share and saw that there were no change to the timestamps to the f...

paul_klump · 02-12-2010

James, So I've been out of the office for the past two days due to inclement weather here in the Northeast, so I let the backup job run over this time. I checked this morning, the job is still labeled as active. I also checked the files in the B2...

paul_klump · 02-09-2010

James, I started the job around 2:40 and stepped away, and hadn't noticed that a "backup-to-disk device is offline" message popped up right away. I set the B2D folder back to online at 3:10 PM, and a few files were created on the disk: 02/09/2010 ...

paul_klump · 02-09-2010

James, I just started another backup job, which I will let run. It's about 2:40 PM EST and I leave for the day around 5:30 PM EST, so I'll check the progress before I leave for the day.

VOX

User Statistics

User Activity

Using a Netgear ReadyNAS 1100 as a Backup-To-Disk Folder target

James, I haven't replied back

James, I had been out of the

James, So I've been out of

James, I started the job

James, I just started another