Run the Intelligent Disaster Recovery Preparation Wizard application with a '-d' switch. That is, if you have your BackupExec installed on C:\BackupExec, then get to a command prompt and run the command C:\BackupExec\drprepwizard.exe -dThe -d swi...
It looks like the components required to show the disk management console are not registered. When you are in the IDR recovery wizard welcome screen, get to a command prompt and make sure you have the B:\I386\BEDRWIZ.INI file present. This file conta...
At the end of a successful full backup, the .DR file is updated with the latest hardware information about the system that is getting backed up. The hardware layout information consists of the harddisks layout and drivers. Driver files required to ac...
When the wizard asks you for the “Path to Windows Operating System Installation files”, provide the drive letter of the operating system installation CD or provide a path where you might have a copy of the complete installation CD. The IDR bootable ...
If you install the latest device drivers for 10d, this should work properly then. You will have to recreate your DR file and IDR CD after installing this, and then run your restore again. Here is the link to the latest drivers:http://seer.entsupport...