cancel
Showing results for 
Search instead for 
Did you mean: 

No Boot After Clean Installation

I attempted to install a clean installation of 3600 R2 on an existing appliance using the USB key.

The installation completed as expected, but it will not boot.

The display is black with a blinking cursor in the Left Upper corner.

 

 

1 Solution

Accepted Solutions
Accepted Solution!

Re: No Boot After Clean Installation

Try to reinstall it as per the DR recovery procedure listed below:

https://www.veritas.com/support/en_US/article.HOWTO60836

Thanks!

View solution in original post

3 Replies
Accepted Solution!

Re: No Boot After Clean Installation

Try to reinstall it as per the DR recovery procedure listed below:

https://www.veritas.com/support/en_US/article.HOWTO60836

Thanks!

View solution in original post

Re: No Boot After Clean Installation

Sounds like incorrect boot order.

Check the BIOS settings and the boot option should be set to use the Embedded RAID Controller (AHCI)

Re: No Boot After Clean Installation

Thanks for the comments. I reset and verified BIOS setting - all is good.