At this point I'm totally confused.
I've checked a job which used a certain partion which in turns uses a tape. I relabled that device partition which formats the contents and tried to backup agian with the same failed result. It does about 3 hours of backing up, then junks out. The tapes are 450 GIG each, and when looking at how far the backup went, it shows "263,859,052,527".
So then I figured I'd make two slots as partitions and try again which again failed with the same result. However, looking at this two slot partition, one of them is a tape and the other one it doesn't appear to be a tape. It says (Cleaning Media) for that one.
So now I've recreated another two slot partition which shows two tapes. I've set the job to use this partition, and I am hoping that it will complete.
Any ideas why this is happening with 450 GIG tapes???
Message Edited by Mikefer on
09-25-2007 12:42 PM