cancel
Showing results for 
Search instead for 
Did you mean: 

Das Band wird zwar ausgeworfen, aber der/die Jobs werden nicht bzw. nicht korrekt beendet.

InoUser
Level 3

Guten Morgen!

So, das Update von Hand hat funktioniert, danke dafür.
Es wurden dann auch alle weiteren Updates wieder per LiveUpdate installiert.

Aber ... ich habe ein weiteres Problem.
Ich hatte gehofft, das es sich mit den Updates erledigt hat, aber leider nicht.

Der Bandauswurf funktioniert nicht korrekt.
Das Band wird zwar ausgeworfen, aber der/die Jobs werden nicht bzw. nicht korrekt beendet.

- Wenn bei einem Sicherungs-Job das Auswerfen mit eingestellt ist, wird das Band ausgeworfen, aber der Job wird einfach nicht beendet!
- Wenn der gleiche Job ohne das Auswerfen eingestellt ist, wird der Job normal beendet.
- Wenn man den Auswurf von Hand durchführt, also dem Gerät über BackupExec sagt: "Auswerfen", dann wird das Band zwar ausgeworfen, aber auch dieser Job wird dann nach einer Weile mit Fehler beendet.

 

MFG

1 ACCEPTED SOLUTION

Accepted Solutions

pkh
Moderator
Moderator
   VIP    Certified

After the tape is ejected, you got to respond to the Media Remove alert so that the job can complete.  Otherwise, go to Tools --> Alert Categories and set up an auto-response for the Media Remove Alert category.

View solution in original post

3 REPLIES 3

pkh
Moderator
Moderator
   VIP    Certified

After the tape is ejected, you got to respond to the Media Remove alert so that the job can complete.  Otherwise, go to Tools --> Alert Categories and set up an auto-response for the Media Remove Alert category.

AmolB
Moderator
Moderator
Employee Accredited Certified

Check the alerts tab in the Backup Exec console, you will find "Media Remove" alerts.

Configure that alert to clear out automatically.

EDIT: Refer to http://www.symantec.com/docs/TECH23213

 

InoUser
Level 3

Morgen!

Problem wurde mit Hilfe der Tipps behoben, Danke. :)