Error - 0x00084af / V-79-57344-33967 / B.E. ver 13.0

[pondomk]

Backup Exec Ver 2010 / 13.0 Rev 2896 (32bit)

This is a file server - with out SQL (which is what everything is pointing to for older versions)

Every day before the Job kicks off I stop and restart the backup exec remote agent on the server.  The backups on this box are getting worse and worse.  Started with access denied to alot of files and folders.  Now its getting -

Any help would be greatly appreciated.

Job ended: Thursday, August 04, 2011 at 8:26:02 PM
Completed status: Failed
Final error: 0xe00084af - The directory or file was not found, or could not be accessed.
Final error category: Job Errors

For additional information regarding this error refer to link V-79-57344-33967

Errors

Click an error below to locate it in the job log Backup- \\server1\c: Directory \\DRSCAPPIMG01\C:\ was not found, or could not be accessed. None of the files or subdirectories contained within will be backed up. Backup- \\server1\NI Directory \\DRSCAPPIMG01\NI\ was not found, or could not be accessed. None of the files or subdirectories contained within will be backed up. Backup- \\server1\OBData_MP07 Directory \\DRSCAPPIMG01\OBData_MP07\ was not found, or could not be accessed. None of the files or subdirectories contained within will be backed up. Backup- \\server1\System?State V-79-57344-65245 - A failure occurred accessing the object list. V-79-57344-65245 - A failure occurred accessing the object list. V-79-57344-65245 - A failure occurred accessing the object list. V-79-57344-65245 - A failure occurred accessing the object list.

[pondomk]

So, I tried a suggestion from another forum post.  I completely rebuilt the job in BU.  New selection list, new job, new everything.   Exact same result on the job.   It runs about 518,120 bytes.. then fails off with the exact same message.

[sbora]

Can you access the files/folders reported in the job log using windows explorer? Can you copy few files/folders for which you get this error to another drive/server and then run a backup from there?

[pondomk]

Yes.. From my BE server, I log in as the backup service account that we use.  I can then go to the \\server1\c$  and write / delete / change / move / create files / delete files / save etc...

Will try to copy some of  the folders to another location and try another backup from that location.

[pondomk]

Yes..  I can copy, move, delete files by simply unc to the server from our BE server, using the service account.  Which is the strange part.  Everything works in windows, and on EVERY other server.  Simply this one server is the issue.

I will see if I can copy some data to another location and try to back up the new location.

[pkh]

Go to the BE installation directory and use BEUtility to repair the BEDB.