I am running a job again to see what the alert is. I will then post it. Yes Sp1 is installed and I did run the utility, and there are no mismatches or any problems.
The backups are normal jpg,xls,word,pdf files.And it is being backedup to a tape. The tape drive is in 100% working condition including the tapes. Newest firmware and drivers. I used a utility from HP to test the tape drive and everything is perfect.
Now the main problem is that it starts backing up files then it gets to a file 334kb a pdf file and it stops.The transfer rate drops to 1mb/min then later disapears. Then the job fails. When I don't include this folder it runs gets to another file and it does the same thing. Even ntbackup does the same thing.
A hardware error has occurred that caused the job to fail. Check the Application
Event log for errors (with Event Source: Backup Exec) that occurred at the time the job stopped, for example:
Event Type: Error
Event Source: Backup Exec
Event Category: Devices
Event ID: 33152
Description:
Adamm Mover Error: Unload Rewind Failure!
Error = ERROR_IO_DEVICE
Drive = "TapeDrive 1"
{DC0CA7FF-815E-4CA9-AB0E-5BC8FE5B5396}
Media = ""
{00000000-0000-0000-0000-000000000000}
Read Mode: SingleBlock(0), ScsiPass(0)
Write Mode: SingleBlock(1), ScsiPass(1)
Final error: 0xe00d84ed
But as I say it only happens when it gets to these few files. It stops. The files are working 100% and are used daily. I have tried doing the backup to a hard drive with the "problem" files and it completes. Could it be the scsi controller? But why does it stop on these files. It should just skip these files if there is a problem?