I think I have seen someone mention this somewhere but I cannot find it again.
We monitor our clients' backup regularly on many different servers. I have noticed that on some of them backup runs only partially and gets canceled with error message "error reading file data" after a restore was run.
Some of those servers have Win2000, others have Win2003. I cannot find correlations but it seems like they are all also SQL servers (as far as I've seen so far).
Does anyone know the cause of this? Any fixes? Thanks much.
Please install Service Pack 3 as mentioned and verify the results. VERITAS Backup Exec (tm) 9.1 for Windows Servers revision 4691 - Service Pack 3 http://support.veritas.com/docs/278302
NOTE : If we do not receive your reply within two business days, this post would be marked assumed answered and would be moved to answered questions pool.
NOTE : If we do not receive your reply within two business days, this post would be marked assumed answered and would be moved to answered questions pool.
According to the link you provided, it seems like this applies to revision numbers 4691, 4691.1, 4691.2.
All of our clients that had recent backup problems have 4691 some with Win2K, some Win2003. However, there is at least one case where they have a very similar setup (with revision #4691) but did not see any problem after a restore. Do you know what else might be involved? Maybe other software or hardware?
It is difficult to isolate the cause of the issue. But this is a known problem since the beginning and hence its fix has been included in Service Pack 3 as well...
Were you able to install Service Pack 3 on any of the servers and was the problem resolved by the service pack?
NOTE : If we do not receive your reply within two business days, this post would be marked ‘assumed answered’ and would be moved to the ‘answered questions’ pool.
Thank you for your response. Unfortunately, we have not been able to implement the fix yet. We have many clients and we are in the process of assessing which servers may have this problem so we can address those first.
Do you know approximately how long it takes to install this SP3?
Installation of patches will depend on the CPU speed, network speed, etc. If there is minimum activity on the server the installation will be faster.
NOTE : If we do not receive your reply within two business days, this post would be marked assumed answered and would be moved to answered questions pool.
We have just installed the SP3 patch on our own server since it also had the same problem of backup not completing after a restore. The patch was installed and the server was rebooted but when I go to Help - About, I still see version 9.1 rev 4691. Is it supposed to say 4691.3? The installation process went without a hitch. How can I confirm that the patch was successfully installed?
I will test the effectiveness of the patch later and report back.