β11-28-2008 03:37 AM
We have 3 tape autoloaders (A, B & C) each with a single drive, all in same device pool.
Whenever we run a restore and the tape is not already loaded it always wants to run the job in loader B and requests to load the tape there.
I've changed the device priorities to 10, 11 & 12 respectively and rebooted but still insists on using B.
Even to the point where I had to do a restore and B was already running a job, 2 drives sat idle but it still wants me to load the required tape to B.
Anyone got any suggestions as to why B is the chosen one?
thanks
running 12.5 rev 2213