Backup Exec 9.1 rev 4691 running on Windows 2000 Server.
I have a tape drive pool of three Compaq 4mm DAT drives, and a drive pool of two HP AIT-3 tape drives.
I want to specify exactly which DAT drive is used first when a backup job starts, and which is used second, etc.
Same with the AIT-3 drive pool, want to specify which drive the backup job should start with.
Can this be done?
The only way I have found is to Inventory DAT drive 1 prior to backup so it shows a tape is inserted, and make sure drives 2 and 3 show "none" in the Device list.
Backup job will start with drive 1, but is always a mystery whether drive 2 or drive 3 will be used next.
Not a problem at this time with the AIT-3 tape drives 1 and 2, since there are only two. But will be adding a third AIT-3 drive to the pool in the near future.
Thank you for any assistance or suggestions.