11-13-2012 12:58 AM
Hello.
All my Oracle/RMAN backups have one copy ( FRAG1 and FRAG2 ).
FRAG1 is in a IBM Tape Library in the Location1, and
FRAG2 is in a SUN Tape Library in the Location2.
How can i tell netbackup to restore from all copies ( all FRAG's ) to speed up the restore?
Normaly the restore jobs run again the FRAG1 and the second Image ( FRAG2 ) is newer needed.
regards
Thomas
Solved! Go to Solution.
11-13-2012 01:11 AM
Hi Thomas,
all I know is that you can only use one copy for restore, and this is the primary copy. You can make copy 2 to primary copy, but then you can also use only this new primary copy for restore.
regards
Dirk
11-13-2012 01:11 AM
Hi Thomas,
all I know is that you can only use one copy for restore, and this is the primary copy. You can make copy 2 to primary copy, but then you can also use only this new primary copy for restore.
regards
Dirk
11-13-2012 01:15 AM
Hi Thomas.
I think you are mixing the Netbackup terms. A Fragment (FRAG) is a piece of data that makes a Netbackup image.
Both tech notes explain how fragment works:
http://www.symantec.com/docs/TECH15692
http://www.symantec.com/docs/HOWTO56051
What I think you are talking about is copies. Basically you have a copy of a backup in both robots and want to restore from both of them concurrent. The not so great answer is: you can't.
Netbackup always has a primary copy where restore are read. You can promote a secondary copy to a primary copy using the bpimage command.
bpimage -npc copy # -backupid backupid
See full docs at: http://www.symantec.com/docs/HOWTO43660
or how to use the GUI at :
http://www.symantec.com/docs/TECH30156