BESR2010 Multiple Errors suddenly happening about 60% into the job.

[helraza]

The system was hardly being used when this image was being created.  I tried to rerun the job and got the same error again.  The location the file is saving to has plenty of free space.  The job ran fine for months until these errors.  Any input would be appreciated.  The OS is server 2003 r2.


Error EC8F17B7: Cannot create recovery points for job: Drive Backup of (C:\), Data (E:\).

Error E7D1001F: Unable to write to file.

Error EBAB03F1: Error performing inpage operation.

Error E7D10046: Unable to set file size.

Error EBAB03F1: Insufficient system resources exist to complete the requested service. (UMI:V-281-3215-6071)

Details: 

Source: Backup Exec System Recovery

[Markus_Koestler]

Give this procedure a try:

1. Click Start, click Run, type regedit in the Open box, and then click OK.
2. Locate and then click the following registry subkey:
HKEY_LOCAL_MACHINE\SYSTEM\CurrentControlSet\Control\Session Manager\Memory Management
3. On the Edit menu, point to New, and then click DWORD Value.
4. Type PoolUsageMaximum as the entry name, and then press ENTER.
5. Right-click PoolUsageMaximum, and then click Modify.
6. Click Decimal.
7. In the Value data box, type 60, and then click OK.
 
Important
Use 60 as your initial value. If your backup does not succeed, use 40 as your value. If that does not work, you must change the behavior of your backup program to reduce the demand of paged pool. If the value works, you may want to increase the value by approximately 25 percent until the backup does not work. If the backup is unsuccessful, use the second registry setting that is described in this article.
Make sure that the value for this registry setting is not more than 60.
If you are using the /3GB switch, use 40 as your initial setting. Note that this value is a percentage value.
8. Quit Registry Editor.
9. Restart your computer.