About jnett

jnett · 09-30-2013

I currently have BE 2010 configured to write nightly backups to 2 SAN volumes at night, with duplicate jobs that run to tape as soon as those finish. However, I don't think I have it configured properly to utilize the 8GB fabric speeds when writing ...

jnett · 09-12-2013

I am trying to backup a powered-off VM from VMWare to BackupExec 2010. Initially this was setup as a network backup, without direct SAN access, and that method worked. I am now trying to get the job to write directly from the SAN (FC) to the tape l...

jnett · 10-07-2013

Sorry for the delay, digging into this again today. Here's what throws me off. I have 1 job that is direct written to tape, no D2D2T involved. It's writing a smaller job, about 300gb of SQL dumps. that job runs right around 5gb/min. Next job i...

jnett · 10-01-2013

My only concern is the second step, duplicating the backups from disk to tape, which if I'm not mistaken should all be over FC to the tape library. It is an LTO 6 drive. Typically backups are running anywhere from 1300mb/sec (which is too slow i th...

jnett · 09-12-2013

Yep, I read through that, that's how I found out it needed to have the datastores presented to the BE server. Did that, still no go. Thanks.

VOX

User Statistics

User Activity

Backup Exec Disk to Disk to Tape, with SAN to Tape direct copy

BackupExec 2010 error backing up VMWare

Sorry for the delay, digging

My only concern is the second

Yep, I read through that,