About bmackey55

bmackey55 · 11-30-2020

I'm actually using VSR ver 21 but that wasn't in the drop-down.I have to install windwos ADK ver 1703 to support access to my Buffalo NAS despite it supporting SMB ver 2. When I create "Typical" SRD WITHOUT the ADK ver 1703 installed it works fine bu...

bmackey55 · 11-15-2020

I recently purchased a new laptop does not have a CD drive so a USB SRD is required. I have been unable to get SRD created that can map a network drive despite IP Config showing being issued and IP address and being able to ping my NAS device where t...

bmackey55 · 05-29-2020

After a re-install of SSR 2013 R2 my VALID license key is no longer accepted.I have check my original purchase receit with the license key to ensure it's accurate but I get the following message (Actual License Key has been edited out for obvious rea...

bmackey55 · 12-03-2020

I don't have any 3rd party anti virus SW installed. I'm only using the out of the box MS stuff.Maybe I'm blind, but I can not find they "Run as a different user" otpion anywhere. I have even located the SRDCreate.exe and ran as administrator. Where i...

bmackey55 · 11-16-2020

akihiro1, WOW what an odd workaround!That was completely successfuly. I tried it with both the "net use" command and in the GUI after "connect using a different user name" option. Both worked successfully.Thank you!Any idea why GUI doesn't show any o...

bmackey55 · 11-16-2020

Thanks akihiro1 for your response.I had already confirmed that SMB v2 was enabled. However, just to be safe, today I upgraded the firmware on my Buffalo LS420D to the latest from 11-28-2019. (See attached screen shot).I have attached pictures from er...

bmackey55 · 11-15-2020

After reading this thread and the "net use" command I was able to map all my shares from other Windows 10 machines but I still can not map the shares from my Buffalo NAS. There are no credentials needed for the Buffalo NAS shares and I have confirmed...

bmackey55 · 06-27-2020

Thank you. That solved the issue for me too.

VOX

User Statistics

User Activity

Error ECA307D2: Failed to open (mount or apply) the WIM file in the Veritas System Recovery Disk mod

SSR 2013 SRD USB Issue - Can't Map Network Drive Despite Being Able to Ping NAS

Symantec System Recovery 2013 R2 License Key Error

Re: Error ECA307D2: Failed to open (mount or apply) the WIM file in the Veritas System Recovery Disk

Re: SSR 2013 SRD USB Issue - Can't Map Network Drive Despite Being Able to Ping NAS

Re: SSR 2013 SRD USB Issue - Can't Map Network Drive Despite Being Able to Ping NAS

Update --> SSR 2013 SRD USB Issue - Can't Map Network Drive Despite Being Able to Ping NAS

Re: Off to a bad start with System Recovery 2013 R2 SP4