Backup exec Inventory issue

[Frank_Chorpenni]

Backup exec 9.1 question - I had a backup job die ( it froze) in the middle of backing up a Netware 6.0 volume, so the job didn't finish properly. When I perform an inventory on the tape from the failed job, it shows one volume that did get backed up but the other one is missing. Is there a way to inventory the tape and see what was backed up from the other volume ( the volume that was getting backed up when the job froze.)?

[Ken_Putnam]

To see what data is on a given tape, go to the Restore Selections pane and select Media view rather than Volume view.

[Frank_Chorpenni]

It doesn't matter which view I use it shows only the one volume, the SYS volume. Is there a way to show what else is on the tape? The tape volume information shows 20 GB is used and the SYS volume is roughly 5 GB. Please help...

[Ken_Putnam]

Shut down all backupExec Services
rename the catalogs directory (ie \Catalogs.sav)
restart BackupExec
inventory
catalog

If that doesn't work, you are probably SOL

(Remember to swap the \Catalog Directory back)

[Frank_Chorpenni]

Thanks for your help... We are SOL..