Backup exec Job status Always shows queued (Exchange 2007)

[supportsib2]

Backup exec Job status Always shows  queued (Exchange 2007) , and it never finish.I cancel many times  but no avail

BAckup Exec 2010

Thank you

[Kiran_Bandi]

are there any active alerts?

Are you backing up to tape or disk?

Regards.......

[supportsib2]

Tape . I had  a  problem in the tape   (End marker unreadable ) , I erased (quick erase )

Then its working . But  why it did nt give me an indication of  the problem

Thanks

[Kiran_Bandi]

Some alert may be there, indicating the problem. just check

[Simon_B_]

There is an option to prevent alerts from popping up. When such situations occur you might want to doubleclick on the alert icon right at the bottom of the console. It is 2 icons left from the server name.

This should show the current alert.

[CraigV]

I've just had exactly the same issue on an HP StorageWorks 1x8 G2 autoloader. Jobs kept on failing randomly. Turns out the tape drive itself had hard-write errors, and it was corrupting the tapes it was writing too.

You can verify any hard/soft-write errors with your drive by going to the Devices tab, and clicking on the drive. Look in the pane below that...anything more than 2 hard-write errors indicates a hardware problem that you should raise with your vendor. It could be that the device is in pre-failure, explaining why there are no alerts to this...