Running into a very bizarre problem that seems to have started about a month ago. I was running 10D and i have a folder on a server that is approx 300GB. its on a iscsi drive array directly attached. Backupexec is running on the server its hooked up to.
When i run a test backup it says it backed up 300GB. When i run the actual job it says completed sucessfully with only 5K backed up.
Its not a permission thing since i already ensured that and if it was the test would fail.
In fact I managed to get it to run once or so but then the next time it just went back to backing up nothing.
I have other jobs running on the same server connecting to other folders on the same ISCSI array and they work 100%. If i take all the files and move them to another folder they back up OK. Its not a corruption since i tried doing a CHKDSK on the drive and it was OK.
After i upgraded to 11D it backed up once OK and then went back to only backing up 5K or just these folders, it doesnt even list the other 3700 folders under the Design Files folder.
Backup Set Detail Information
Directory \
Directory \Design Files
Directory \Design Files\DfsrPrivate
Directory \Design Files\DfsrPrivate\ConflictAndDeleted
Directory \Design Files\DfsrPrivate\Staging
Backup completed on 11/23/2006 at 9:02:21 PM.
Backup Set Summary
Backed up 0 files in 5 directories.
Processed 5,312 bytes in 5 seconds.
Throughput rate: 0.061 MB/min
This backup set may not contain any data.
Job ended: Thursday, November 23, 2006 at 9:02:22 PM
Completed status: Successful