12-14-2011 09:56 AM
Hi
I'm running Backup Exec 2010 R3 with HP MSL 4048 Auto Loader that contain 2x LTO 5 drives.
I created a restore job, the data is on 3 differnet LTO tapes, but BE doesnt seem to use both drives for the restore even when i choose "ALL DEVICES" in the restore properties.
I can however, run a backup job on one drive, and a restore job on another drive.
I have the Backup Exec Library Expansion Option installed.
Thank You.
Dori
Solved! Go to Solution.
12-14-2011 10:20 AM
This is by design
Once a Tape job starts, it will only continue on the same drive after a tape is swapped out, either on a Backup or a Restore job. if all tapes required for a Restore job are mounted in the Library and a Scan or Inventory was done when they were loaded, the tapes should swap out automatically
(You can run two different jobs at the same time on the two drives)
12-14-2011 10:20 AM
This is by design
Once a Tape job starts, it will only continue on the same drive after a tape is swapped out, either on a Backup or a Restore job. if all tapes required for a Restore job are mounted in the Library and a Scan or Inventory was done when they were loaded, the tapes should swap out automatically
(You can run two different jobs at the same time on the two drives)
12-14-2011 11:18 AM
Thank you!