08-24-2017 02:53 AM
Hello,
Our networkteam is building a new network with lots of WAN connections. We planned to replicate / duplicate between our sites. They want to know what ports Netbackup wil use. All the sites have Netbackup 7.7.3, I did some searching, but it is important that I give the right info to then.
It looks like MSDP to MSDP uses spad/10102 and spoold/10082 on the destination. This is the port where the traffic will go on. There are also lots of other ports which are used by Netbackup, but I just need to know where the big data stream is. They will limit those ports to the need of the backup. QoS.
Regards,
Rob
08-24-2017 03:07 AM
08-25-2017 02:02 AM
Hello Marianne,
I have red that document, I just wanted to be sure I wasn't forgetting anything.
Thanks anyway,
Rob
08-25-2017 02:06 AM
You may well also need tcp/1556 and tcp/13724 between Master Servers for trust and command and control. I did also need these two ports for:
site A - one single master/media 5230 Appliance
...replicating to... and replicating from...
site B - one single master/media 5230 Appliance
.
So, for the above, I needed four ports open, in each direction: tcp/1556, 13724, 10082, 10102.
08-25-2017 04:09 AM
ok thanks, but the main traffic for the dup/rep goes over the 10082, 10102?
That is what they want to do. Limit the traffic of the ports where the whole lot travels. That way the backup will not consume the whole bandwith of the WAN connection.
08-29-2017 01:42 AM
Yes, tcp/1556 tcp/13724 are for command and control. So, yes, if you are able to QoS specific ports tcp/10082 and tcp/10102 then yes you could control peak sustained bandwidth usage.